USA / English
Latinoamérica / EspañolMAGHEX 2 Fan Controller for Hydraulic and Engine Cooling Systems
Type
Hydraulic Oil Cooling / Accessories
This combined sensor and controller is designed to mount directly to the heat exchanger. Smart temperature-based controller for oil and coolant fan systems in mobile and industrial applications.
It provides accurate temperature control by cycling the electric cooling fan to maintain desired oil temperature. A single housing reduces wiring and mechanical installation. The MAGHEX magnetic wand is used to set up and program the sensor. Not needed for operation. LEDs indicate the oil temperature setting.
- PN 59649 -8 SAE M thread connection for heat exchanger.
- MA Series
- PN 600181 3/8” NPT thread connection for heat exchanger.
- M/MF and DH/DF Series
MAGHEX Programming Wand
Consult catalog for additional sizes and technical information.
-
Easy installation and integration into any SAE-8 (59649) or 3/8″ NPT (600181) port or cavity.
- Creates a simple drive circuit with minimal programming.
- Low cost alternative to complex control systems.
- Utilize built-in temperature sensor to activate the fan based upon current set point.
- Oil temperature status shown as below, at, or 20°F above set point.
- 12 or 24 volt DC operation controlling up to 60 amps.
- Temperature sensor and operation controller in single aluminum housing.
- Select from 10 temperature settings from 100° to 200°F (38° to 93°C).
- Solid-state design, fully sealed microprocessor.
- Manual override feature built-in.
- Shuts off 7 degrees below set point.
- Improved circuitry to accommodate higher amperage applications.
- Housing is used as a heat sink for internal components.
- Automatic low voltage shut down.
- -SAE -8 (M) (PN 59649) and 3/8″ NPT (M) (PN 600181) thread connection.
- Remote Sensing available, contact factory.
- Operating Voltage: 12 or 24 VDC Systems
- Min/Max Voltage: 9 VDC / 32 VDC
- Current Rating: 60 AMPS
- Switch Type: Normally open
- Ambient Operating Temperature: -40°F to +185°F (-40° to +85°C)
- Measurement Temperature Range: 100°F to 200°F (38° to 93°C)
- Current Draw MAGHEX: 20 mA
- Setpoint Selections: 10 set points in 10 degree increments from 100°F to 200°F (38° to 93°C)
- Selection Method: Magnetic programming wand
- Enclosure Rating: IP69K
- Sealed Housing: High-grade Automotive Potting Compound
- Housing Material: Anodized Aluminum
- Weight: Approx 8 oz. (.23 kg) incl. wire
- Fan Connector: 3 Conductor Receptacle
The MAGHEX 2 controller connects directly with electric fan systems used in hydraulic and engine-cooling applications. It ensures reliable, intelligent temperature-based fan control in compact cooling packages.